The bass cabinet project is nearing completion. The whole idea was to try and provide a kind of “domestic” setup to provide an “acceptable” level of real tube driven bass. The practicalities of the project mean that I won’t actually be able to assess the sonic capabilities of the cabinet, until the very end. Meanwhile – there’s no going back on any of the design decisions, or construction now.
Time to revisit the small bass cabinet I’ve been working on. I’ve basically been waiting for the speaker to arrive. I’ve also had the chance to source the grille cloth, trim and port tubes to finish the build. Now I have the speaker and port tubes – I can plan out and cut the openings in the front baffle. It’s probably the most critical part of the build, in terms of accuracy. It’s the first time I’ve done any of this kind of thing. There may be tears before bedtime…
To finish the Tolex covering – I need to complete the job on the back panel. This panel will need periodic removal – so I need to take a bit of care not to gum everything up with contact adhesive. Once the basic enclosure is complete – I can fit it out with acoustic “egg box” foam, to muffle any internal sound reflection. The end result should be a sturdy, air tight and acoustically neutral enclosure – ready for the furnishing and fitting of the front baffle, speaker and ports.
The basic cabinet construction is ready for fitting out. The baffle, with its’ separate covering, speaker and port installation, will be a project all on its’ own. For now, I have to make cut-outs in the carcass to accommodate the handles and speaker jack socket. Then, the cabinet will get covered in Tolex. I haven’t done anything like this before – so I’m going mostly on instinct, although I’ve searched for a few tips by watching a few hours of YouTube instructional videos. What could possibly go wrong?
The basic cabinet construction needs some battens installing. These will eventually allow for the baffle, and rear panels, to be screwed into place. If the basic construction is straight and square – this should be pretty straightforward. There’s a bit of routing required, as well, to roundover the cabinet edges – on the FBJ extension cabinet too.
It’s woodwork week at Garageland. While I’ve got the router set up for the bass cabinet project – I might as well get both of the basic constructions underway, while I have the necessary tools out. This will follow much the same procedure as the ported bass cabinet – but with addition of a couple of small, extra panels on the front face. I’ve also had to make some changes to the intended design – so it will now end up as a much simpler, open backed enclosure.
Time to turn this pile of wood into a bass cabinet. First thing is to construct the basic cabinet box. With the timber already pre-cut – this should be straightforward enough. But a sturdy and accurate construction is required.